Slide on the embroidery unit. Select the embroidery designs you wish from your embroidery card/disk. Use your Pictogram pen to mark the center point of each design on the lining piece where you like to place them. In the original casserole holder sample, the embroideries were placed at the each of each short side with the center of the design approximately 10cm from the edge of the fabric. Embroider all four designs. (if you do not have an embroidery option - continue to the next step)

1. Place the two pieces of the lining on top of the batting.

2. Take the standard ankle and presser foot off the machine.

3. Attach the Dual Feed Foot. Remember to place the fork of the foot over the needle clamp screw. Screw in place with the accessory thumbscrews.

4. Quilt across the two pieces as desired or as suggested in the illustrations.

5. Overcast the edges with the three step zigzag.